Cncdesigns Zero Clearance Inserts (5 Pack) for DeWalt DWE7485 Table Saw (Color varies)

5 ZERO CLEARANCE BLANK INSERTS COMPATBLE WITH MODEL DWE7485 ONLY. *** THE INSERTS ARE NOT DESIGNED TO WORK WITH A RIVING KNIFE IN PLACE. YOU NEED TO REMOVE THE MOUNTING HARDWARE FOR YOUR RIVING KNIFE BEFORE YOU RAISE YOUR BLADE. OTHERWISE, THE HARDWARE WILL PUSH THE INSERT UP.. ***THE INSERTS ARE MEANT TO FRICTION FIT BUT LEVELING SCREWS ARE PROVIDED AS WELL. LIGHT SANDING OF THE ROUND EDGES MAY BE REQUIRED. ****MATERIAL IS MDF. COLOR OF THE INSERT VARIES. ***Warning: The plates are not designed to enable installing the lock/release button on the saw. If you want to have that option, you should drill and tape the little “ears” on the saw corresponding to the pre-drilled holes in the inserts. ZERO CLEARANCE INSERTS ARE CALIBRATED TO A SPECIFIC SAW, A SPECIFIC BLADE, AND A SPECIFIC BEVEL ANGLE. THEY CAN ONLY BE USED ON CUTS WHERE THOSE PARAMETERS ARE MET. FOR EXAMPLE, ONCE AN INSERT IS MADE FOR A STRAIGHT-ON 90° CUT, IT CAN’T BE USED ON OTHER CUTS. IF YOU NEED TO MAKE A 45° BEVEL CUT, YOU CAN’T USE YOUR 90° CUT INSERT. YOU MUST HAVE A 45° INSERT, OR SWAP IN THE ORIGINAL THROAT INSERT. EACH ZERO CLEARANCE INSERT IS GOOD FOR ONLY ONE SPECIFIC BEVEL ANGLE.

• INSERT FITS ONLY THE DWE7485 MODEL
• ***DO NOT PURCHASE FOR DCS7485 OR DW745 OR ANY OTHER SAW MODEL
• ***WARNING: ZERO CLEARANCE INSERTS ARE NOT INTENDED TO WORK WITH THE RIVING KNIFE IN PLACE. IF YOU KEEP IT IN PLACE, THE HARDWARE WILL HIT THE PLATE FORCING IT TO POP OUT OF PLACE. IF YOU WANT TO USE YOUR RIVING KNIFE, YOU WILL NEED TO MAKE CUTOUTS FOR IT OR USE AN MJ SPLITTER.